subject
Physics, 20.08.2019 06:50 ReaLily

What are six traits of a good scientific observer

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 00:30
Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)
Answers: 1
question
Physics, 22.06.2019 07:30
Boxing gloves are padded to lessen the force of a blow. (a) calculate the force exerted by a boxing glove on an opponent’s face, if the glove and face compress 7.50 cm during a blow in which the 7.00-kg arm and glove are brought to rest from an initial speed of 10.0 m/s. (b) calculate the force exerted by an identical blow in the gory old days when no gloves were used and the knuckles and face would compress only 2.00 cm. (c) discuss the magnitude of the force with glove on. does it seem high enough to cause damage even though it is lower than the force with no glove?
Answers: 1
question
Physics, 22.06.2019 14:20
4r-134a enters the condenser of a residential heat pump at 800 kpa and 50°c at a rate of 0.022 kg/s and leaves at 750 kpa subcooled by 3°c. the refrigerant enters the compressor at 200 kpa superheated by 4°c determine (a) the isentropic efficiency of the compressor, (b) the rate of heat supplied to the heated room, and (c) the cop of the heat pump. also, determine (d) the cop and rate of heat supplied to the heated room if this heat pump operated on the ideal vapor-compression cycle between the pressure limits of 200 and 800 kpa. (0.757, 4.37 kw, 5.12, 6.18, 3.91 kw)
Answers: 3
question
Physics, 22.06.2019 14:20
Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.
Answers: 1
You know the right answer?
What are six traits of a good scientific observer...
Questions
question
Mathematics, 18.02.2022 09:00
question
Mathematics, 18.02.2022 09:00
question
Mathematics, 18.02.2022 09:00