Answers: 3
Physics, 23.06.2019 07:50
In a particular chemical reaction, the energy of the reactants is 30 kj and the energy of the products is 5 kj. 
 the maximum energy of the system is 40 kj. sketch a potential energy diagram for this reaction. make sure to label the energy of the reactants, the energy of the products, the activation energy, and the enthalpy change for the reaction.
Answers: 2
Physics, 23.06.2019 13:30
The goal of this experiment was to answer the question, "how does diffraction occur? " suppose you formulated this alternate hypothesis: if the gap width is increased while keeping wavelength constant, then the observed diffraction will decrease because the less the ratio between wavelength and gap width is, the smaller the observed diffraction angle will be.to test this hypothesis, you would change the gap widthdiffraction anglewavelength and observe the gap widthdiffraction anglewavelength in the system.therefore, the independent variable would be the gap widthdiffraction anglewavelength and the dependent variable would be the gap widthdiffraction anglewavelength.
Answers: 1
Physics, 23.06.2019 18:00
The steel pipe ab has a 102-mm outer diameter and a 6-mm wall thickness. knowing that arm cd is rigidly attached to the pipe, determine the principal stresses and the maximum shearing stress magnitude at point k. (round the final answers to one decimal place.) given: f = 10 kn
Answers: 2
An Electric heater reted 12V is used to heat 450g of water when a current of 5A is passed through it...
Computers and Technology, 28.11.2019 04:31