subject
Physics, 17.02.2022 23:50 jessicawelch25

The indirect method is used to determine total power in a parallel circuit when that power is determined from the total current, total resistance, and source voltage.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 22:00
Atank holds 1000 gallons of water, which drains from the bottom of the tank in half an hour. the values in the table show the volume v of water remaining in the tank (in gallons) after t minutes.t(min) 5 10 15 20 25 30v(gal) 694 444 250 111 28 0(a) if p is the point (15, 250) on the graph of v, find the slopes of the secant lines pq when q is the point on the graph with t = 5, 10, 20, 25, and 30.(b) estimate the slope of the tangent line at p by averaging the slopes of two secant lines.(c) use a graph of the function to estimate the slope of the tangent line at p. (this slope represents the rate at which the water is flowing from the tank after 15 minutes.)show all steps.
Answers: 2
question
Physics, 22.06.2019 07:00
Hen a gfci receptacle device is installed on a 20-ampere branch circuit (12 awg copper), what is the minimum volume allowance (in cubic inches) required for conductor fill for each conductor in the outlet box?
Answers: 1
question
Physics, 22.06.2019 09:50
Which statement correctly describes the current in a circuit that is made up of any two resistors connected in parallel with a battery? a. the current in the battery and in each resistor is the same b. the current the battery equals to the sum of the currents in the resistors c.the current in the battery is less than the current in either resistor d. the current in the battery equals to the product of the currents in the resistors
Answers: 1
question
Physics, 22.06.2019 23:10
Atorque acting on an object tends to produce a. equilibrium b. rotation c. linear motion d. velocity e. a center of gravity
Answers: 2
You know the right answer?
The indirect method is used to determine total power in a parallel circuit when that power is determ...
Questions
question
French, 30.01.2020 14:53