subject
Physics, 06.02.2022 01:00 randallmatthew5665

I need help in those ones


I need help in those ones

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 07:50
The ratio of lift to drag l/d for a wing or airfoil is an important aerodynamic parameter, indeed, it is a direct measure of the aerodynamic efficiency of the wing. if a wing is pitched through a range of angle of attack, l/d first increases, then goes through a maximum, and then decreases. consider an infinite wing with an naca 2412 airfoil. estimate the maximum value of l/d. assume that the reynolds number is 9x10^6.
Answers: 2
question
Physics, 22.06.2019 09:30
For this car, predict the shape of a graph that shows distance (x) versus time (t). note that time is the independent variable and will be on the bottom axis. need asap
Answers: 1
question
Physics, 22.06.2019 21:10
Two masses are connected by a rope that hangs over a pulley as shown below. the pulley is a uniform cylinder of radius ν‘…=0.381meters and mass ν‘€=3.1ν‘˜ν‘”. initially ν‘š"is on the ground and ν‘š#rests 2.5 meters above the ground. if the system is released, use conservation of energy to determine the speed of ν‘š#just before it strikes the ground. assume the pulley bearing is frictionless.
Answers: 2
question
Physics, 23.06.2019 02:10
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what β€œx” and β€œy” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is β€œsmooth”.
Answers: 1
You know the right answer?
I need help in those ones
...
Questions