subject
Physics, 03.01.2022 09:40 vieraml58

Students made an electromagnet by wrapping a wire in loops around an iron nail and attaching the wire to a battery, as shown below.
The students conducted a test to learn how the number of wire loops affected the
number of paper clips held by the electromagnet. The table below shows the results
of the test.
Number of wire loops
10
20
30
40
Number of paper clips held
2
4
7
9
Based on the information from the table, which of the following is the outcome
(dependent) variable in this experiment?


Students made an electromagnet by wrapping a wire in loops around an iron nail

and attaching the

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
question
Physics, 22.06.2019 05:00
Which of the following is the result of the nuclear weak force? the instability of large nuclei the repelling force between positively charged protons the structure of the atom certain types of nuclear decay
Answers: 2
question
Physics, 22.06.2019 11:00
Looking at this barometer, is the air pressure high or low? what type of weather would you expect? high, bad low, bad high, good low, good
Answers: 1
question
Physics, 22.06.2019 12:30
Consider a 1000 w iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-t6 (ρ = 2770 kg/m3 and cp = 875 j/kg°c). the base plate has a surface area of 0.03 m2. initially, the iron is in thermal equilibrium with the ambient air at 22°c. assuming 90% of the heat generated in the resistance wires is transferred to the plate, determine the minimum time needed for the plate temperature to reach 200°c.
Answers: 1
You know the right answer?
Students made an electromagnet by wrapping a wire in loops around an iron nail and attaching the w...
Questions