subject
Physics, 06.10.2021 19:00 alliaespino

(A) The figure shows the setup which is used to observe an image formed wen a lighted candle is kept in front of a bi convex lense. 1. Can the image be formed on the screen or not when the lighted candle is moved from F (focus) towards P (pole)?

2. Sketch the ray diagram to show how the image is formed by the lens when the candle is kept in between F and P.

3. Write 2 characteristics of the image formed in the above ray diagram.

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 01:00
Calculate the amount of heat produced when 18000 coulombs of charge is transferred in one hour through a potential difference of 50v
Answers: 3
question
Physics, 22.06.2019 21:20
Astone is dropped from the upper observation deck of a tower, 250 m above the ground. (assume g = 9.8 m/s2.) (a) find the distance (in meters) of the stone above ground level at time t. h(t) = (b) how long does it take the stone to reach the ground? (round your answer to two decimal places.) s (c) with what velocity does it strike the ground? (round your answer to one decimal place.) m/s (d) if the stone is thrown downward with a speed of 2 m/s, how long does it take to reach the ground? (round your answer to two decimal places.) s
Answers: 3
question
Physics, 23.06.2019 01:20
Afisherman notices that his boat is moving up and down periodically, owing to waves on the surface of the water. it takes a time of 2.70 s for the boat to travel from its highest point to its lowest, a total distance of 0.700 m. the fisherman sees that the wave crests are spaced a horizontal distance of 6.50 m apart. a. how fast are the waves traveling? b. what is the amplitude a of each wave?
Answers: 1
question
Physics, 23.06.2019 06:30
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
You know the right answer?
(A) The figure shows the setup which is used to observe an image formed wen a lighted candle is kept...
Questions
question
Business, 14.04.2020 00:14