subject
Physics, 24.09.2021 08:20 natalie2sheffield

Let's assume the following data was obtained in Atwood's Pulley system. The heavier mass was falling from a height of 0.85 meters and the acceleration of this fall was calculated as 0.175 m/s2. What is the average time of the fall?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 23:30
Which lists the main components of darwin’s theory of evolution? a. random mutations drive evolution; the evolution of a population happens slowly; organisms have common ancestors; organisms do not change. b. natural selection drives evolution; the evolution of a population happens slowly; organisms have common ancestors; organisms change over time. c. natural selection drives evolution; the evolution of a population happens rapidly; organisms have common ancestors; organisms change over time. d. random mutations drive evolution; the evolution of a population happens rapidly; organisms have common ancestors; organisms do not change.
Answers: 1
question
Physics, 22.06.2019 09:30
Astone is dropped from a cliff and falls 9.44 meters. what is the speed of the stone when it reaches the ground? a. 13.6 m/sec b. 1.39 m/sec c. 185 m/sec d. 9.80 m/sec
Answers: 3
question
Physics, 22.06.2019 10:30
Agroup of students were investigating the force of gravity. they began by dropping a foam ball from a height of 3 meters into a bucket of sand. the ball hit the sand in 0.306 seconds. they dropped additional balls of approximately the same diameter, but of different masses. here is the data they collected. based on this experiment and the collected data, what would their conclusion be?
Answers: 1
question
Physics, 22.06.2019 16:50
Consider the growth of a 20-nm-diameter silicon nanowire onto a silicon wafer. the temperature of the wafer surface is maintained at 2400 k. assume the thermal conductivity of the silicon nanowire is 20 wm-1k-1 and all its surfaces including the tip are subjected to convection heat transfer with the coefficient h = 1Γ—105 wm-2k-1 and t∞ = 8000 k. when the nanowire grows to l = 300 nm, what is the temperature of the nanowire tip (t (x =
Answers: 1
You know the right answer?
Let's assume the following data was obtained in Atwood's Pulley system. The heavier mass was falling...
Questions
question
Mathematics, 24.11.2021 14:50
question
Mathematics, 24.11.2021 14:50
question
English, 24.11.2021 14:50