subject
Physics, 12.09.2021 04:40 zookieblu

1.at constant temperature a gas occupy 50cm³ at 10mmhg calculate the work done 2.if normal human body temperature is 34 °c, what is the equivalent value in fahrenheit

3. A stone is thrown upward from ground with a velocity of 40m/s. how long does it take to reach the highest point

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 20:40
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
question
Physics, 21.06.2019 22:50
A110-pound person pulls herself up 4.0 feet. this took her 2.5 seconds. how much power was developed? 0.13 hp 0.32 hp 2.0 hp 3.1 hp
Answers: 1
question
Physics, 21.06.2019 23:20
The 5-kg cylinder is initially at rest when it is placed in contact with the wall b and the rotor at a. if the rotor always maintains a constant clockwise angular velocity v = 6 rad> s, determine the initial angular acceleration of the cylinder. the coefficient of kinetic friction at the contacting surfaces b and c is mk = 0.2.
Answers: 3
question
Physics, 22.06.2019 00:00
True or false: the cycle of seasons on the earth is caused by the tilt of the earth on its axis toward and away from the sun.
Answers: 1
You know the right answer?
1.at constant temperature a gas occupy 50cm³ at 10mmhg calculate the work done 2.if normal human b...
Questions
question
Mathematics, 23.04.2020 23:13
question
Chemistry, 23.04.2020 23:14
question
Social Studies, 23.04.2020 23:14
question
Mathematics, 23.04.2020 23:14