subject
Physics, 01.09.2021 03:10 Akkenson17871

The freefall acceleration on the moon is 1/6 of its value on earth. suppose he hit the ball with a speed of 25m/s an angle of 30 above the horizontal. a. how long was the ball in flight?
b. how far did it travel?
c. How much farther would it travel on the moon than on earth?

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 02:00
Askydiver weighing 140 lb (including equipment) falls vertically downward from an altitude of 19,000 ft and opens the parachute after 18 s of free fall. assume that the force of air resistance, which is directed opposite to the velocity, is of magnitude 0.55|v| when the parachute is closed and is of magnitude 14|v| when the parachute is open, where the velocity v is measured in ft/s. assume that acceleration due to gravity has magnitude 32 ft/s/s; remember that weight is the product of mass and gravitational acceleration. (a) find the speed of the skydiver when the parachute opens. (b) find the distance fallen before the parachute opens. (c) what is the limiting velocity vl after the parachute opens? (d) determine how long the sky diver is in the air after the parachute opens. (e) plot the graph of velocity versus time from the beginning of the fall until the skydiver reaches the ground.
Answers: 1
question
Physics, 22.06.2019 18:30
Anonzero net force acts on a particle and does work. which one of the following statements is true? the kinetic energy of the particle changes, but the speed of the particle does not change. the kinetic energy of the particle does not change, but the speed of the particle does change. the kinetic energy of the particle changes, but the velocity of the particle does not change. the kinetic energy and the speed of the particle change, but the velocity of the particle does not change. the kinetic energy, speed, and velocity of the particle change.
Answers: 1
question
Physics, 23.06.2019 01:00
How much work would it take to move a coulomb charge across a 4 volt potential difference?
Answers: 2
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
The freefall acceleration on the moon is 1/6 of its value on earth. suppose he hit the ball with a s...
Questions
question
Social Studies, 04.10.2021 02:20
question
History, 04.10.2021 02:20
question
History, 04.10.2021 02:30
question
Mathematics, 04.10.2021 02:30
question
Mathematics, 04.10.2021 02:30