A constant volume thermometer consists of a rigid bulb and a pressure gauge. To obtain accurate results, this thermometer must be calibrated at a known pressure and temperature. Once this is done, the bulb is sealed off from the atmosphere. The volume and number of moles of gas can no longer change and the temperature is calculated from the pressure measurement * 25% Part(a) A particular constant volume thermometer is calibrated by opening it to the atmosphere while the bulb is in a bath of boiling water. Enter an expression for the temperature of the thermometer in degrees Celsius, in terms of its pressure, P. in atmospheres 779)- 37.15 1CP). 27315 X Atep Remain * 25%

Part(b) When the constant volume thermometer that was calibrated as described in part(a) is used to measure a temperature, it shows a pressure of 10.95 atm. What temperature is it indicating, in degrees Celsius?

First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit

Awave travels at a speed of 5.2 m/s. if the distance between crests is 0.40 m, what is the frequency of the wave? use f=v/wavelength a. 13 hz b. 2.1 hz c. 0.077 hz d. 5.6 hz

Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2