subject
Physics, 19.05.2021 21:40 brayden2275

ASAP What is typical of a precondition? A precondition is a condition that should be met before a method runs. A typical precondition is that the data used by the method must be . Another is that a particular must be reached before the method will run.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
question
Physics, 22.06.2019 14:30
Which compound is held together by the electrostatic force between two ions? a. co2 b. cci4 c. h2s d. mgf2
Answers: 1
question
Physics, 22.06.2019 14:30
Which of the following changes will increase the capacitance of a parallel-plate capacitor? (there could be more than one correct choice.) a) increase the charge on the plates b) decrease the poten5al between the plates c) increase the potential between the plates d) introduce a dielectric material between the plates e) decrease the separation between the plates
Answers: 3
question
Physics, 22.06.2019 18:30
A1000-kg car is moving at 30 m/s around a horizontal unbanked curve whose diameter is 0.20 km. what is the magnitude of the friction force required to keep the car from sliding?
Answers: 3
You know the right answer?
ASAP What is typical of a precondition? A precondition is a condition that should be met before a m...
Questions
question
Mathematics, 29.06.2019 13:00