SCIENCE In the article, you read that "The Gimli base had no control tower or fire trucks, and was being used
as a racetrack." What physical detail from the story supports why this being a racetrack could be a
serious problem for the pilots?
It had been divided into various courses, including a drag strip with a steel guardrail down the middle.
It was family day at the track
Spectators and racers had to scatter as the plane touched down
Because the nose landing gear was not extended, the tail of the plane ended up three stories in the air

In a bumper car arena, two cars of equal mass are heading straight toward each other. the orange one is traveling at a speed of 5 meters per second. the green one is traveling at a speed of 2 meters per second. which of the forces most affects the motion of the bumper cars after they collide? a) gravity b) friction c) the other car d) wind resistance

The key to stability is feedback between the reservoir and the fluxes into and/or out of the reservoir. assume that the rate of outflow from a reservoir depends on the size of the reservoir according to the following relationship: outflow rate= k x (size of reservoir), where k is a constant. a reservoir of water has a volume of 5000 liters, and the rate of outflow at steady state is 25 liters per minute. what is k? (give both the numerical value and its units.) what is the residence time? what is the relationship between k and the residence time?

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).