Physics, 29.04.2021 01:20 M1CK3Y

A single output device has failed while the remainder of the PLC system is functioning normally The indicator light on the output module indicates that a signal is sent to the output point where the device is connected. You would now: a) trace the circuit back through the logic to locate the inputs.

b) use a programming terminal to call up the rung that controls the output to see if the output coil is on.

c) check the point where the output device's field wiring is connected to the output rack.

d) check the input modules for short-circuit conditions.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 03:00

Arotating space station is said to create “artificial gravity”—a loosely-defined term used for an acceleration that would be crudely similar to gravity. the outer wall of the rotating space station would become a floor for the astronauts, and centripetal acceleration supplied by the floor would allow astronauts to exercise and maintain muscle and bone strength more naturally than in non-rotating space environments. if the space station is 200 m in diameter, what angular velocity would produce an “artificial gravity” of 9.80 m/s^{2} 2 at the rim?

Answers: 3

Answer

Physics, 22.06.2019 05:30

Anybody wanna ? (picture included? )

Answers: 1

Answer

Physics, 22.06.2019 11:00

Aperson walks first at a constant speed of 4.89 m/s along a straight line from point a to point b and then back along the line from b to a at a constant speed of 2.95 m/s. what is the average speed over the entire trip?

Answers: 1

Answer

Physics, 22.06.2019 17:00

Two conductors, a and b, are each in the shape of a tetrahedron. but of different sizes. they are charged in the following manner: 1. tetrahedron a is charged from an electrostatic generator to charge q. 2. tetrahedron a is briefly touched to tetrahedron b. 3. steps 1 and 2 are repeated until the charge on tetrahedron b reaches a maximum value. if the charge on tetrahedron b was q/4 after the first time it touched tetrahedron a. what is the final charge qbmax on tetrahedron b?

Answers: 2

Answer

You know the right answer?

A single output device has failed while the remainder of the PLC system is functioning normally The...

Questions