Physics, 17.09.2019 14:20 nanakwameyeb

In a scientific experiment, the variable manipulated or controlled by the experimenter is called the

Answers: 2

Show answers

Answers

The variable manipulated or controlled by the experimenter is called the independent variable.

Example:
If the flow velocity at the bottom of a tank is measured by varying the height of water in the tank, we are measuring velocity as a function of water height.
Therefore,
water height = independent variable (controlled)
velocity = dependent variable (measured in response to water height).

Mathematically,
v = f(h)
where v = response variable (dependent)
h = controlled variable (independent).

Answer from: Quest

so here is the information for current research:

-nrel's geothermal analysts, scientists, and engineers perform a full range of research from developing advanced methods of locating and accessing geothermal resources to exploring innovative technologies to extract and produce clean energy from the heat of the earth

and here is the information for the technology of geothermal energy:

-it's clean and sustainable

-resources of geothermal energy range from the shallow ground to hot water and hot rock found a few miles beneath the earth's surface, and down even deeper to the extremely high temperatures of molten rock called magma

-almost everywhere, the shallow ground or upper 10 feet of the earth's surface maintains a nearly constant temperature between 50° and 60°f (10° and 16°c)

-geothermal heat pumps can tap into this resource to heat and cool buildings

-a geothermal heat pump system consists of a heat pump, an air delivery system (ductwork), and a heat exchanger-a system of pipes buried in the shallow ground near the building

-in the winter, the heat pump removes heat from the heat exchanger and pumps it into the indoor air delivery system

-in the summer, the process is reversed, and the heat pump moves heat from the indoor air into the heat exchanger

-the heat removed from the indoor air during the summer can also be used to provide a free source of hot water

Answer from: Quest

it would be c. predictability

Another question on Physics

Physics, 22.06.2019 04:50

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?

Answers: 1

Answer

Physics, 22.06.2019 10:00

How are the crust and the inner core alike? a) they are both solid. b) they both have the same temperature. c) they are both under the same pressure. d) they are both very close to the center of the earth.

Answers: 1

Answer

Physics, 22.06.2019 13:00

Which of the following correctly describes what happens when an atomic bomb explodes? small pieces of fissionable material are joined and form a body with a mass greater than the critical mass, the relative number of neutrons escaping decreases, and a chain reaction and explosion result. large pieces of fissionable matter are brought together quickly and form a body with a mass smaller than the critical mass, the relative number of escaping neutrons increases, and a chain reaction and explosion result.

Answers: 2

Answer

Physics, 22.06.2019 23:30

With physics question #5? for any !

Answers: 1

Answer

You know the right answer?

In a scientific experiment, the variable manipulated or controlled by the experimenter is called the...

Questions