Tony uses the device shown in the diagram to model how an electromagnet is used in his uncle’s scrap metal yard.
not sure how to get the diagram - a battery held up by a nail with coiled wire
after picking up several staples with the device, what change would enable tony to drop the staples in the scrap metal bin?
1. removing the
2. removing the iron
3. moving the wire loops closer
4. spreading the wire loops farther

Suppose water is leaking from a tank through a circular hole of area ah at its bottom. when water leaks through a hole, friction and contraction of the stream near the hole reduce the volume of water leaving the tank per second to cah 2gh , where c (0 < c < 1) is an empirical constant. a tank in the form of a right-circular cone standing on end, vertex down, is leaking water through a circular hole in its bottom. (assume the removed apex of the cone is of negligible height and volume.) (a) suppose the tank is 20 feet high and has radius 8 feet and the circular hole has radius 2 inches. the differential equation governing the height h in feet of water leaking from a tank after t seconds is dh dt = − 5 6h3/2 . if the height of the water is initially 8 feet, how long will it take the tank to empty? (round your answer to two decimal places.)

An ideal otto cycle has a compression ratio of 10.5, takes in air at 90 kpa and 40°c, and is repeated 2500 times per minute. using constant specific heats at room temperature, determine the thermal efficiency of this cycle and the rate of heat input if the cycle is to produce 90 kw of power.

Two 2.0-cm-diameter disks face each other, 1.0 mm apart. they are charged to ±10 nc. what is the electric field strength between the disks? a proton is shot from the negative disk toward the positive disk. what launch speed must the proton have to just barely reach the positive disk?