subject
Physics, 16.09.2019 10:30 skoolroks

And ice cream truck is going 25 m/s to the east it accelerates to 40 m/s in the same direction over three seconds what is it acceleration

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 20:30
Ahorizontal wire is tied to supports at each end and vibrates in its second-overtone standing wave. the tension in the wire is 5.00 n, and the node-to-node distance in the standing wave is 6.28 cm. (a) what is the length of the wire? (b) a point at an anti- node of the standing wave on the wire travels from its maximum upward displacement to its maximum downward displacement in 8.40 ms. what is the wire's mass?
Answers: 3
question
Physics, 22.06.2019 14:20
Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.
Answers: 1
question
Physics, 22.06.2019 19:40
Two charged particles, q1 and q2, are located on the x-axis, with q1 at the origin and q2 initially at x1 = 12.2 mm. in this configuration, q1 exerts a repulsive force of 2.62 µn on q2. particle q2 is then moved to x2 = 18.0 mm. what is the force (magnitude and direction) that q2 exerts on q1 at this new location? (give the magnitude in µn.)
Answers: 1
question
Physics, 22.06.2019 19:40
It may seem strange that the selected velocity does not depend on either the mass or the charge of the particle. (for example, would the velocity of a neutral particle be selected by passage through this device? ) the explanation of this is that the mass and the charge control the resolution of the device--particles with the wrong velocity will be accelerated away from the straight line and will not pass through the exit slit. if the acceleration depends strongly on the velocity, then particles with just slightly wrong velocities will feel a substantial transverse acceleration and will not exit the selector. because the acc
Answers: 1
You know the right answer?
And ice cream truck is going 25 m/s to the east it accelerates to 40 m/s in the same direction over...
Questions
question
Advanced Placement (AP), 24.06.2019 17:30
question
Social Studies, 24.06.2019 17:30