Physics, 24.09.2019 20:30 rhettnyah

What is the magnitude of the centripetal acceleration of an object on earth's equator owing to the rotation of earth?

Answers: 1

Show answers

Answers

Answer from: Quest

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

Answer from: Quest

One splits the atoms and molecules the other combines them

Answer from: Quest

force is based upon mass and acceleration.the statement is not always true.

it can be explained from newton's second law of motion.

as per newton's second law of motion the rate of change of momentum is directly proportional to the applied force and takes place along the direction of force.

mathematically it can be written as -

$f\alpha \frac{dp}{dt}$

⇒ $f= k \frac{dp}{dt}$

here k is the proportionality constant whose value is 1.

$f=\frac{dp}{dt}$

$f= \frac{d[mv]}{dt}$

$f= m\frac{dv}{dt} +v\frac{dm}{dt}$

$f=ma+v\frac{dm}{dt}$ [a is the acceleration=dv/dt]

hence we see that force not only depends on mass and acceleration but also on velocity and rate of change of mass. force f will depend on mass and acceleration only when mass is constant.

hence the statement that force is based upon mass and acceleration is false.

Answer from: Quest

Global warming was a major concern some people do not care global warming is fake it is not real the percentage of it happening is slight

Another question on Physics

Physics, 22.06.2019 15:40

How does the electric potential energy between two charged particles change if one particle is reduced by a factor of 3? a. increased by a factor of 3 b. it is decreased by a factor of 9 c. it is reduced by a factor of 3 d. it is increased by a factor of 9

Answers: 1

Answer

Physics, 23.06.2019 00:40

Asteel tube (k=50 w/mk) of inner and outer diameter di = 20mm and do=26mm, respectively, is used to transfer heat from hot gases flowing over the tube (h-hot = 200w/m2k) to cold water flowing through the tube (h-cold = 8000 w/m2k). what is the cold-side overall heat transfer coefficient uc? to enhance heat transfer 16 straight fins of rectangular profile are installed longitudinally along the outer surface of the tube. the fins are equally spaced around the circumference of the tube, each having a thickness of 2mm and a length of 15mm. what is the corresponding overall heat transfer coefficient uc? *solve for uc in both cases*

Answers: 1

Answer

Physics, 23.06.2019 01:30

At what time would the magnitude of the velocity reach 36.00 km/hr

Answers: 2

Answer

Physics, 23.06.2019 16:10

Wich factors affect the electrical force between two objects?

Answers: 3

Answer

You know the right answer?

What is the magnitude of the centripetal acceleration of an object on earth's equator owing to the r...