subject
Physics, 16.12.2019 13:31 dimondqueen511

Which statement is true about groundwater flow?

groundwater flows from zones of low pressure to zones of high pressure.

groundwater does not flow but stays in one location until pumped upward.

groundwater moves downward by gravity and from areas of high pressure to areas of low pressure.

groundwater circulates in a convection current manner.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 15:50
Aneutron and a proton combine to form a nucleus. why does the mass of the nucleus differ from the sum of the masses of the individual nucleons?
Answers: 1
question
Physics, 21.06.2019 22:00
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
question
Physics, 21.06.2019 23:10
What happens in a global convection cell
Answers: 1
question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
You know the right answer?
Which statement is true about groundwater flow?

groundwater flows from zones of low pre...
Questions
question
Mathematics, 27.08.2019 05:10
question
Business, 27.08.2019 05:10
question
Biology, 27.08.2019 05:10