subject
Physics, 13.04.2021 19:10 smithsa10630

In a swimming pool, two sets of waves were produced in different ways. One set of waves was produced by a child jumping into the water off of a diving board A second set of waves was produced by the same child rapidly kicking his legs while seated on the edge of the pool. Which wave model corresponds to each set of waves produced? Use evidence and scientific reasoning to support your answer.​


In a swimming pool, two sets of waves were produced in different ways. One set of waves was produce

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 23:00
How many dots must be added to the symbol to properly represent a standard nitrogen ion? a) 1 b) 3 c) 5 d) 8
Answers: 1
question
Physics, 22.06.2019 03:30
As part of an industrial process, air as an ideal gas at 10 bar, 400k expands at steady state through a valve to a pressure of 4 bar. the mass flow rate of air is 0.5 kg/s. the air then passes through a heat exchanger where it is cooled to a temperature of 295k with negligible change in pressure. the valve can be modeled as a throttling process, and kinetic and potential energy effects can be neglected. (a) for a control volume enclosing the valve and heat exchanger and enough of the local surroundings that the heat transfer occurs at the ambient temperature of 295 k, determine the rate of entropy production, in kw/k. (b) if the expansion valve were replaced by an adiabatic turbine operating isentropically, what would be the entropy production? compare the results of parts (a) and (b) and discuss.
Answers: 3
question
Physics, 22.06.2019 10:00
Awater-filled u-tube manometer is used to measure the pressure inside a tank that contains air. the water level in the u-tube on the side that connects to the tank is 5 ft above the base of the tank. the water level in the other side of the u-tube (which is open to the atmosphere) is 2 ft above the base. determine the pressure within the tank.
Answers: 2
question
Physics, 22.06.2019 13:00
Aplayground merry-go-round has a radius of 4.6 m and a moment of inertia of 200 kg-m2 and turns with negligible friction about a vertical axle through its center. a child applies a 26.0 n force tangentially to the edge of the merry-go-round for 15.0 seconds. if the merry-go-round is initially at rest, how much work did the child do on the merry-go-round?
Answers: 1
You know the right answer?
In a swimming pool, two sets of waves were produced in different ways. One set of waves was produced...
Questions
question
Mathematics, 28.06.2019 16:10