Physics, 29.01.2020 05:00 jjgurl60

Acar goes around a curve on a road that is banked at an angle of 34.5^\circ . even though the road is slick, the car will stay on the road without any friction between its tires and the road when its speed is 18.0 m/s. what is the radius of the curve? a car goes around a curve on a road that is banked at an angle of 34.5^\circ . even though the road is slick, the car will stay on the road without any friction between its tires and the road when its speed is 18.0 m/s. what is the radius of the curve?

Answers: 1

Show answers

Answers

Answer from: christyr2002

A car goes around a curve on a road that is banked at an angle of 30.0 . Even though the road is slick, the car will stay on the road without any friction between its tires and the road when its speed is 21.0 m/s

What is the radius of the curve?

Go to the web site below for a diagram of a maximum velocity on banked curve with friction problem!!

http://
hyperphysics.phy-astr.gsu.edu/hbase/mec...

Force centripetal force = mass * (velocity^2 ÷ radius)

The centripetal force is a horizontal force directed toward the center of the curve. You need to determine the sum of the forces that are directed toward the center of the curve.

The road exerts a force on the tires of the car. This force is perpendicular to the inclined surface, and is labeled N.

For the car to remain at the same vertical position, the sum of the vertical forces must equal 0 N.

Without friction:
The horizontal component of the Normal force = N * sin θ

Eq. #1
m * (v^2 ÷ r) = N * sin θ
m * (18^2 ÷ r) = N * sin 34.5°

The vertical component of N = N * cos θ
Weight is a negative vertical force = -(m * g)
For the car to remain at the same vertical position, the sum of the vertical forces must equal 0 N.

N * cos 34.5°+ -(m * 9.8) = 0

Eq. #2
m * 9.8= N * cos 34.5°
When you divide Eq. #1 by Eq. #2, m on the left side of the equal sign will cancel, and N on the right side of the equal sign will cancel.

18^2 ÷ (r * 9.8) = sin 34.5° / cos34.5° = tan 34.5°
Solve for r

18^2 = r * 9.8 * tan 34.5
r = 18^2 ÷ (9.8 * tan 34.5)

r = 48.10 meters

Answer from: Quest

the grams of oxygen gas that can be produced is 20.6 grams of o₂

calculation

2liclo₃ → 2 licl + 3 o₂

step 1: find the moles of liclo₃

moles = mass÷ molar mass

from periodic table the molar mass of liclo₃ =6.9 +35.5 +(16 x3) =90.4 g/mol

moles=38.7 g÷90.4 g/mol=0.4281 moles

step 2: use the mole ratio to calculate the moles of o2

from equation above, liclo₃: o₂ is 2: 3

therefore the moles of o₂=0.4281 moles x3/2 =0.6422 moles

step 3: find mass of o₂

mass= moles x molar mass

from periodic table the molar mass of o₂ = 16 x2= 32 g/mol

mass=0.6422 moles x 32 g/mol = 20.6 grams of o₂

Answer from: Quest

answer: good job it's all correct !

explanation:

Iwill mark as the brainliest answer check if the answers are correct

Another question on Physics

Physics, 21.06.2019 18:10

How does the space charge width change with forward and reverse bias? also, calculate the space charge width for a reverse bias of 4v on a silicon pn junction at t = 300k and doping concentrations of na = 5x1015cm-3 , nd = 5x 1016 cm-3 .

Answers: 3

Answer

Physics, 22.06.2019 10:30

An insulated 40 ft^3 rigid tank contains air at 50 psia and 120°f. a valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. the air temperature during this process is kept constant by an electric resistance heater placed in the tank. determine the electrical work done during this process.

Answers: 2

Answer

Physics, 22.06.2019 14:20

4r-134a enters the condenser of a residential heat pump at 800 kpa and 50°c at a rate of 0.022 kg/s and leaves at 750 kpa subcooled by 3°c. the refrigerant enters the compressor at 200 kpa superheated by 4°c determine (a) the isentropic efficiency of the compressor, (b) the rate of heat supplied to the heated room, and (c) the cop of the heat pump. also, determine (d) the cop and rate of heat supplied to the heated room if this heat pump operated on the ideal vapor-compression cycle between the pressure limits of 200 and 800 kpa. (0.757, 4.37 kw, 5.12, 6.18, 3.91 kw)

Answers: 3

Answer

Physics, 23.06.2019 00:20

What efficiency of a car's engine when heat input is 200,000 joules and waste heat is 150,000 joules? a. 75% b. 35% c. 25% d. 85%

Answers: 2

Answer

You know the right answer?

Acar goes around a curve on a road that is banked at an angle of 34.5^\circ . even though the road i...

Questions