Scanning Power (4x) = mm; mm X 1000 = μm Low Power (10x) = mm; mm X 1000 = μm High power (40x) = mm; mm X 1000 = μm Which objective lens (on the microscopes in the lab) provides the largest field of view? Which objective lens (on the microscopes in the lab) provides the smallest field of view? Is field of view directly or inversely related to magnification?

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

show the wavelengths of a wave. show the crests of a wave.

current and voltage can both be different in different parts of a circuit so it matters where you place the ammeter and voltmete

when a device is used in a circuit in which the voltage is 81 v, the current flowing through the device is 3 a. what is the resistance of the device?

a. 27 ω

b. 40.5 a

c. 243 ω

d. 243 a

the correct answer is a. 27