Answers: 2
Physics, 22.06.2019 08:20
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
Physics, 22.06.2019 09:00
As a pendulum bob swings back and forth several times, the maximum height it reaches becomes less and less. this is because more and more of the pendulum bob's energy is being transformed into a. heat energy b. kinetic energy c. potential energy d. kinetic energy and potential energy
Answers: 2
Physics, 22.06.2019 16:40
Aparticle's position is given by x = 3.00 - 9.00t + 3t2, in which x is in meters and t is in seconds. (a) what is its velocity at t = 1 s? (b) is it moving in the positive or negative direction of x just then? (c) what is its speed just then? (d) is the speed increasing or decreasing just then? (try answering the next two questions without further calculation.) (e) is there ever an instant when the velocity is zero? if so, give the time t; if not, answer "0". (f) is there a time after t = 3 s when the particle is moving in the negative direction of x? if so, give the time t; if not, answer "0".
Answers: 3
Physics, 22.06.2019 19:00
If state law mandates that elevators cannot accelerate more than 2.40 m/s2 or travel faster than 14.8 m/s , what is the minimum time in which an elevator can travel the 373 m from the ground floor to the observatory floor? ?
Answers: 1
A mustang, has an average velocity of 33 m/s while covering a course that is 21 miles long. (1 mile...
Geography, 12.03.2020 20:31
History, 12.03.2020 20:31
Mathematics, 12.03.2020 20:31
History, 12.03.2020 20:31
Social Studies, 12.03.2020 20:31