Lucy had two cubes of equal volume, one made of concrete and one made of plastic foam. She placed them on a table and gave each cube an equal push in order to change the cubes' states of motion. Based on Newton's law of inertia, Lucy's results concluded that objects. A. with greater Mass have less inertia

B. with greater mass have more inertia.

C. of the same density have the same inertia.

D. of equal volume have equal inertia.​

During physical science, ms. greene challenged her students to produce an energy transformation. james and jill wrapped a 4-inch nail with a coil of fifty turns of wire. they connected one end of the coil to one terminal of a knife switch. they connected the other terminal of the knife switch to the battery. finally, they connected the end of the coil to the other terminal of the battery. james held the tip of a 1-inch nail near the flat end of the 4-inch nail. jill closed the knife switch quickly and then opened it. the 1-inch nail was pulled toward the 4-inch nail. what is the best explanation of why the nail moved? a) electrical energy was converted to mechanical energy in the 1-inch nail. b) the 4-inch nail became an electromagnet and the magnetic force attracted the 1-inch nail. c) the electric current in the 4-inch nail was converted to mechanical energy in the 1-inch nail. d) the 4-inch nail had a positive charge and the 1-inch nail had a negative charge. opposites attracted.

Why is metal often used for cooking pan?

Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.