Physics, 18.02.2021 20:50 larissa1013

A toy car rolls at a constant speed down a straight inclined track. When the car reaches the flat surface at the base of the inclined track, the speed of the car decreases.
Which statement best explains why the speed of the car decreases when it reaches the flat
surface?
o
A. The force of gravity acting on the car increases.
B. The force of gravity on the car decreases.
C. The forces influencing the car are not balanced.
D. The forces influencing the car are balanced.

Answers: 1

Show answers

Answers

Answer from: Quest

moving ball hits still ball. mover stops, hit ball moves. momentum transfer.

Answer from: Quest

a solenoid is created by wrapping a l = 90 m long wire around a hollow tube of diameter d = 4.5 cm. the wire diameter is d = 0.9 mm. the solenoid wire is then connected to a power supply so that a current of i = 9 a flows through the wire.

randomized variablesl = 90 m

d = 4.5 cm

d = 0.9 mm

i = 9 a

write an expression for the number of turns, n, in the solenoid. you do not need to take into account the diameter of the wire in this calculation.

calculate the number of turns, n, in the solenoid.

write an expression for the length of the solenoid (l2) in terms of the diameter of the hollow tube d.

calculate the length of the solenoid (l2) in meters.

calculate the magnitude of the magnetic field at the center of the solenoid in teslas.

explanation:

Answer from: Quest

trig 15.3 cos

Answer from: Quest

force is based upon mass and acceleration.the statement is not always true.

it can be explained from newton's second law of motion.

as per newton's second law of motion the rate of change of momentum is directly proportional to the applied force and takes place along the direction of force.

mathematically it can be written as -

$f\alpha \frac{dp}{dt}$

⇒ $f= k \frac{dp}{dt}$

here k is the proportionality constant whose value is 1.

$f=\frac{dp}{dt}$

$f= \frac{d[mv]}{dt}$

$f= m\frac{dv}{dt} +v\frac{dm}{dt}$

$f=ma+v\frac{dm}{dt}$ [a is the acceleration=dv/dt]

hence we see that force not only depends on mass and acceleration but also on velocity and rate of change of mass. force f will depend on mass and acceleration only when mass is constant.

hence the statement that force is based upon mass and acceleration is false.

Another question on Physics

Physics, 22.06.2019 01:30

Question 7 [2 marks] in the circuit below, the electromotive force generated by the battery is e = 6.0 v, and the resistances are r1 = r4 = 1.0 q, r2 = r3 =2.0 q. r. the power delivered by the battery to the circuit is closest to a. 6 w в. 12 w с. 15 w d. 18 w e. 20 w final exam autumn 2014 page 5 of 9 68037 physical modelling faculty of science [2 mark] question 8 with reference to question 7, the current through resistor r2 is closest to a. 1 a в. 2 а c. 3 a d. 4 a e. 6 a

Answers: 2

Answer

Physics, 22.06.2019 04:00

19. explain why a magnet from your refrigerator could not be used to lift something as heavy as a car. (chapter 7 – pages 202-203) 20. can a magnet ever have a single pole? explain your answer. (chapter 7 – page 208) 21. what happens to the wavelength of a wave if the frequency is increased? (chapter 9 – pages 280-281) 22. an ocean wave has a wavelength of 10 m and a frequency of 4.0 hz. what is the velocity of the wave? show the appropriate equation from your book and show your work with units. (chapter 9 – page 282) 23. as you sit outside, the sound of a siren becomes lower in pitch. is the emergency vehicle moving away from or towards you? explain how you know. (chapter 10 – page 315-316) 24. why are two astronauts in space unable to hear one another? (chapter 10 – page 307) 25. explain in at least 3 sentences how electromagnetic waves form. (chapter 11 – page 338-339) 26. using the chart on page 345 in your textbook, what are the three types of electromagnetic wave with wavelengths shorter than those of visible light. give an example of each. (chapter 11 – pages 345-351) 27. explain why a leaf usually appears to be green, but a rose typically appears red. (chapter 12 – page 373) 28. what is the difference in light that is refracted compared to light that is reflected? think in terms of speed of light as well as what happens to light waves when they interact with a medium. (chapter 12 – pages 369-370) 29. how are concave and convex lenses different? (chapter 13 – page 408-410) 30. what type of mirror is used in rearview mirrors in cars? why is it important that these mirrors have the warning, “objects in mirror are closer than they appear.”? (chapter 13 – page 405)

Answers: 3

Answer

Physics, 22.06.2019 13:20

Ahanging spring stretches by 35.0 cm when an object of mass 450 g is hung on it at rest. in this situation, we define its position as x = 0. the object is pulled down an additional 18.0 cm and released from rest to oscillate without friction. what is its position x at a moment 84.4 s later? express your answer in cm.

Answers: 1

Answer

Physics, 22.06.2019 18:10

A200-n force is applied to the foot-operated air pump. the return spring s exerts a 2.6-n·m moment on member oba for this position. determine the corresponding compression force c in the cylinder bd. if the diameter of the piston in the cylinder is 40 mm, estimate the air pressure generated for these conditions. state any assumptions. enter a positive number for the compression force c.

Answers: 2

Answer

You know the right answer?

A toy car rolls at a constant speed down a straight inclined track. When the car reaches the flat s...

Questions