subject
Physics, 11.02.2021 22:40 annagwhiteou0hrh

Two rods, one made of brass and the other made of copper, are joined end to end. The length of the brass section is 0.400 m and the length of the copper section is 0.800 m . Each segment has cross-sectional area 0.00700 m2 . The free end of the brass segment is in boiling water and the free end of the copper segment is in an ice-water mixture, in both cases under normal atmospheric pressure. The sides of the rods are insulated so there is no heat loss to the surroundings. (a) What is the temperature of the point where the brass and copper segments are joined?
(b) What mass of ice is melted in 5.00 min by the heat conducted by the composite rod?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 17:10
An air-standard stirling cycle operates with a maximum pressure of 600 psia and a minimum pressure of 10 psia. the maximum volume of the air is 10 times the minimum volume. the temperature during the heat rejection process is 100°f. calculate the specific heat added to and rejected by this cycle, as well as the net specific work produced by the cycle. use constant specific heats at room temperature. the properties of air at room temperature are r
Answers: 2
question
Physics, 22.06.2019 10:20
Asmall object with mass 0.200 kg swings back and forth on the lower end of a light rope that is 3.00 m long. the upper end of the rope is attached to the ceiling. as the object swings through its lowest position, where the rope is vertical, the speed of the object is 5.80 m/s. at this point in the motion, what is the tension in the rope? (use g = 9.80 m/s2.)
Answers: 2
question
Physics, 22.06.2019 14:30
Two carts, one of mass 2m and one of mass m, approach each other with the same speed, v. when the carts collide, they hook together. assume that positive momentum is to the right. which graph best represents the momentum of both carts over time, before and after the collision?
Answers: 3
question
Physics, 22.06.2019 17:20
You charge a parallel-plate capacitor, remove it from the battery, and prevent the wires connected to the plates from touching each other. when you increase the plate separation, what happens to the following quantities?
Answers: 1
You know the right answer?
Two rods, one made of brass and the other made of copper, are joined end to end. The length of the b...
Questions