A local community has land for a park located along a river. The bank is starting to erode. Citizens want to use ideas based on science to solve the erosion problem. Which idea would best help this community protect the riverbank from eroding? A. Adding more soil to the bank will protect existing land from eroding away.
B. Watering the bank daily will make existing soil heavier so it will not erode.
C. Building a rock wall along the bank will keep soil in place so water cannot erode it away.
D. Allowing individuals to walk near the edge of the bank will compact the soll so it will not erode,

if there is something other then the answer just comment it.

C.

Explanation:

This is to support from being eroded a foundation to that will separate the water from the soil and to avoid it from being eroded.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

an electric circuit