What is the doppler effect in astronomy used for?

Aprojectile is launched horizontally 10m above the ground and with an initial velocity of 15 m/s. a) sketch the trajectory using an appropriate coordination system. b) how long for the projectile to reach the ground. c) how far did projectile travel horizontally before striking the ground. d) determine the projectilex & y position at t-1.3s e) determine the magnitude and direction of projectile velocity at t= 1.3s f) determine the magnitude and direction of projectile acceleration at t-1.3s

I'm kinda lost ! 1. when marilyn takes her pet dog for a walk, the dog walks at a veryconsistent pace of 0.55 m/s. draw a position-time graph to representmarilyn's dog walking the 19.8 m distance from the front of her house tothe nearest fire hydrant.2. both car a and car bleave school when a stopwatch reads zero. car atravels at a constant 75 km/h, and car b travels at a constant 85 km/h.a) draw a position-time graph showing the motion of both cars. howfar are the two cars from school when the stopwatch reads 2 hrs? calculate the distances and show them on your graph.b) both cars passed a gas station 120 km from the school. when dideach car pass the gas station? calculate the times and show themon your graph.3. the figure below shows the position-time graph showing a shopper'smovement up and down the aisle at a store.a) write a story describing the shopper's movements at the store.b) when does the shopper have a position of 6 m? c) how much time passes between when the shopper enters the aisleand when he gets to a position of 12 m? what is the shopper's averagevelocity between 37 s and 46 s?

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)