subject
Physics, 24.08.2019 00:00 mariaaalopezz

Among the intermolecular forces, which forces are typically the weakest? multiple
a. dipole-dipole interactions
b. hydrogen bonds
c. dipole-induced dipole interactions
d. london dispersion forces

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 18:30
Will a heavier bowling ball hit pins better than a lighter bsll
Answers: 2
question
Physics, 22.06.2019 11:30
(2) (a) you have a simple circuit that consists of only a battery (δvbat=1.5v) and two resistors with resistance r1=10ω and r2=5ω, connected in series with each other. what is the current running through the battery? (b) you re-arrange your circuit so now r2 is attached in parallel to r1 rather than in series. what is the current running through the battery? (c) you add an additional resistor r3=7ω on the same branch as r2. what is the current running through the battery? (d) what is the power dissipated in r3?
Answers: 3
question
Physics, 22.06.2019 16:30
In the nineteenth century, gregor mendel first determined some basic rules of genetics that have been observed throughout all types of life. no observations have disproved these basic rules of genetics. charles darwin developed the idea of biological evolution around the same time, but he was unaware of mendel’s discoveries in genetics. over a century later, darwin’s idea of evolution was modified in order to incorporate mendel’s rules of genetics along with the other evidence that darwin had used. what is most likely the relationship between mendel’s rules of genetics and darwin’s idea of biological evolution? a.)mendel’s genetics states laws that are now part of the theory of biological evolution.b.)biological evolution states laws that are part of mendel’s theory of genetics.c.)mendel’s genetics replaced darwin’s entire concept of biological evolution.d.)biological evolution is a law that explains why all genetics exist.
Answers: 1
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
You know the right answer?
Among the intermolecular forces, which forces are typically the weakest? multiple
a. dipole-...
Questions