10. Joe places two solid objects in contact with each other. Which property determines the direction of the flow of heat between the two objects?
A. Material of the objects.
B. Volume of the objects.
C. Density of the objects.
D. Temperature of the objects.

Alow cost, low earth orbit (leo) satellite is to be fabricated at a university, for subsequent launch by rocket. what are the constraints and objectives for selection of a material suitable for the satellite bus (i.e. the structure)? explain each in brief. (15 marks) b)suggest sources of data which could support the selection of materials for applications in space. (5 marks) c) set weights for the objectives listed in (2a) using the digital logic method. (5 marks)

Amachinist turns the power on to a grinding wheel, at rest, at time t = 0 s. the wheel accelerates uniformly for 10 s and reaches the operating angular velocity of 96 rad/s. the wheel is run at that angular velocity for 40 s and then power is shut off. the wheel slows down uniformly at 1.5 rad/s2 until the wheel stops. in this situation, the time interval of deceleration is closest to:

At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.