Question 5 of 20 A person throws a 0.12-kg ball straight up into the air. It reaches a height of 15 m. What is the force on the ball as it begins to fall? (The acceleration due to gravity is 9.81 m/s2) O A. 4.32 N B. 2.06 N C. 5.45 N D. 1.18 N

Awind turbine is initially spinning at a constant angular speed. as the wind's strength gradually increases, the turbine experiences a constant angular acceleration 0.173 rad/s2. after making 2870 revolutions, its angular speed is 132 rad/s. (a) what is the initial angular velocity of the turbine? (b) how much time elapses while the turbine is speeding up?

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.