Students are asked to design an experiment about Newton’s 2nd Law. One student decides to roll a marble down a ramp into a pile of sand to measure the force impact. Which variable should she manipulate to best exemplify the relationship explained by this law?

A. She should use a heavier marble, because the marbles will roll at the same rate of acceleration but more mass will produce a larger impact force.

B. She should increase the slope of the ramp by propping it up to higher height, because a steeper ramp will cause a greater rate of acceleration and a larger impact force.

C. She should use a heavier marble, because a bigger marble will accelerate more quickly down the ramp and cause a greater impact force.

D. She should decrease the slope of the ramp, because a ramp with a smaller slope will allow the ball more time to build up speed and cause a greater impact force.

The particle in a two-dimensional well is a useful model for the motion of electrons around the indole ring (3), the conjugated cycle found in the side chain of tryptophan. we may regard indole as a rectangle with sides of length 280 pm and 450 pm, with 10 electrons in the conjugated p system. as in case study 9.1, we assume that in the ground state of the molecule each quantized level is occupied by two electrons. (a) calculate the energy of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels. 9.27 electrons around the porphine ring (4), the conjugated macrocycle that forms the structural basis of the heme group and the chlorophylls. we may treat the group as a circular ring of radius 440 pm, with 20 electrons in the conjugated system moving along the perimeter of the ring. as in exercise 9.26, assume that in the ground state of the molecule quantized each level is occupied by two electrons. (a) calculate the energy and angular momentum of an electron in the highest occupied level. (b) calculate the frequency of radiation that can induce a transition between the highest occupied and lowest unoccupied levels.

1. how to locate the image in converging(concave) mirror and diverging (convex) mirror with salt. 2. how to locate the image in a converging (convex) lens and diverging (concave) lens with salt.

Air is to be preheated by hot exhaust gases in a cross-flow heat exchanger before it enters the furnace. air enters the heat exchanger at 95 kpa and 20°c at a rate of 0.6 m^3/s. the combustion gases (cp = 1.10 kj/kg°c) enter at 160°c at a rate of 0.95 kg/s and leave at 95°c. determine the rate of heat transfer to the air and its outlet temperature.