subject
Physics, 17.11.2020 21:40 mai1261

A sled with a mass of 32 kg is being pulled across the snow. If the friction force between the sled and the ground is 12 N, what is the force needed to accelerate the sled at a rate of 1.1 m/s2?

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 03:10
Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.
Answers: 2
question
Physics, 22.06.2019 16:30
Each neuron shown in this figure innervates a group of muscle fibers. what is the term for a group of muscle fibers innervated by a single neuron?
Answers: 1
question
Physics, 23.06.2019 01:30
Aball is thrown vertically upwards from the top of a tower with a speed of 100m/s.it strikes the pound near the base of the tower after 25sec . the height of the tower is
Answers: 3
question
Physics, 23.06.2019 02:10
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
You know the right answer?
A sled with a mass of 32 kg is being pulled across the snow. If the friction force between the sled...
Questions
question
Mathematics, 19.11.2020 14:00
question
Mathematics, 19.11.2020 14:00
question
Mathematics, 19.11.2020 14:00
question
English, 19.11.2020 14:00
question
Social Studies, 19.11.2020 14:00