Physics, 04.11.2020 16:50 missheyward30

A circuit consists of a wire, a lightbulb, a switch, and a battery. What would happen if the switch were replaced with a section of wire?
O A. The voltage would decrease, and the resistance would increase.
O B. The voltage and resistance would be the same.
Ο Ο
C. The voltage would increase, and the resistance would decrease.
D. The voltage and resistance would both decrease

A circuit consists of a wire, a lightbulb, a switch, and a battery. What would

happen if the swit

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 03:00

If a spring has a k value of 100 newtons per meter and it is stretched 0.50 meters, what is the restoring force of the spring?

Answers: 2

Answer

Physics, 22.06.2019 12:40

Question part points submissions used suppose that 2 j of work is needed to stretch a spring from its natural length of 26 cm to a length of 36 cm. (a) how much work is needed to stretch the spring from 28 cm to 32 cm? (round your answer to two decimal places.)

Answers: 2

Answer

Physics, 22.06.2019 15:20

Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2

Answers: 2

Answer

Physics, 23.06.2019 01:40

(8%) problem 12. a bowling ball of mass mb 3 kg 's rolled down the lane with a velocity ofy-2/ m s lt strikes a single remaining pin mp 0.93 kg head on. after the collision the bowling ball has a velocity (in the same direction) of v2 1.1 m/s. = ▲ 33% part (a) write an expression for the velocity of pin in the horizontal direction after the impact, im ,, 33% part (b) what is the pins speed in ms? 33% part (c) assuming the coefficient of friction s μ,-0.1. how far in meters could the pin slide before stopping if it doesn't topple?

Answers: 1

Answer

You know the right answer?

A circuit consists of a wire, a lightbulb, a switch, and a battery. What would happen if the switch...

Questions