You and a friend have been given the task of designing a display for the Physics building that will demonstrate the strength of the electric force. Your friend comes up with an idea that sounds neat theoretically, but you're not sure it is practical. She suggests you use an electric force to hold a marble in place on a sloped plywood ramp. She would get the electric force by attaching a uniformly charged semicircular wire near the bottom of the ramp, laying the wire flat on the ramp with each of its ends pointing straight up the ramp. She claims that if the charges on the marble and ring and the slope of the ramp are chosen properly, the marble would be balanced midway between the ends of the wire. Required:
Calculate the necessary amount of charge on the marble for a reasonable ramp angle of 15 degrees and a semicircle of radius 10 cm with a charge of 800 micro-coulombs. The marble would roll in a slot cut lengthwise into the center of the ramp. The mass of the lightest marble you can find is 25 grams.

a.) is the correct answer.

explanation:

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

russian is not my first language, so i'm afraid i can't write out an answer in russian, but hopefully you can find a way to do so. here's my best translation of the problem: you're given a plot of a particle's position in one-dimensional space over time, and you're asked to find either the total distance traveled by the particle after 6 seconds had elapsed, or the total displacement of the particle after 6 seconds.

if you want the total distance traveled, you would first need to determine the particle's velocity as a function of time, then integrate that over the 6-second interval. we know the position function is quadratic with roots at 0 and 6, so we have

where is unknown. because the position is parabolic, there is symmetry about the midpoint at , and we know that

so that the position function is

which means the velocity is

then the total distance traveled is

so the total distance traveled is 20 m.

on the other hand, if you want to find displacement: the particle starts at and ends at , so its displacement is 0.

find the surface area of the sphere to the nearest square unit. use a calculator.

a. 254 in.2

b. 64 in.2

c. 127 in.2

d. 1,018 in.2