subject
Physics, 12.08.2020 23:01 amanda7835

Where is the first airplane made

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
Jason and mia are both running in a race. as they approach the finish line, you being the physicist that you are decide to time how long it takes them to reach the end of the race. when you start your stop watch (you can take this as time t = 0 s) you notice that mia is an unknown distance d ahead of jason and both are moving with the same initial velocity v_0. you also notice that jason is accelerating at a constant rate of a_j, while mia is deaccelerating at a constant rate of -a_m. jason and mia meet each other for the first time at time t = t_1. at this time (t = t_1) jason's velocity is two times that of mia's velocity, meaning v_j (t_1) = 2v_m (t_1). a) draw the position vs. time graph describing mia's and jason's motion from time t = 0 to time t = t_1. clearly label your axes and initial conditions on your graph. b) draw the velocity vs. time graph describing mia and jason's motion from time t = 0s to time t = t_1. clearly label your axes and initial conditions on your graph. c) how long from when the stop watch was started at t = 0s did it take mia and jason to meet? express your answer in terms of know quantities v_0, a_m, and a_j. d) when the stop watch started at time t = 0s, how far apart, d, were mia and jason? express your answer in terms of know quantities v_0, a_m, and a_j.
Answers: 1
question
Physics, 22.06.2019 01:10
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
question
Physics, 22.06.2019 07:20
The softest and hardest minerals are: softest hardest
Answers: 1
question
Physics, 22.06.2019 10:50
The temperature at a point (x, y) is t(x, y), measured in degrees celsius. a bug crawls so that its position after t seconds is given by x = 6 + t , y = 8 + 1 3 t, where x and y are measured in centimeters. the temperature function satisfies tx(3, 9) = 5 and ty(3, 9) = 4. how fast is the temperature rising on the bug's path after 3 seconds? (round your answer to two decimal places.)
Answers: 3
You know the right answer?
Where is the first airplane made...
Questions
question
Mathematics, 06.01.2021 02:10
question
Biology, 06.01.2021 02:10
question
Mathematics, 06.01.2021 02:10