subject
Physics, 12.08.2020 04:01 nakarelinp0p303

Monochromatic light with wavelength 588 nm is incident on a slit with width 0.0351 mm. The distance from the slit to a screen is 2.7 m. Consider a point on the screen 1.3 cm from the central maximum. Calculate (a) θ for that point, (b) α, and (c) the ratio of the intensity at that point to the intensity at the central maximum.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 20:40
The metric unit of electrical power is the watt volt ampere ohm
Answers: 1
question
Physics, 22.06.2019 09:00
Atelevision set that has been running for a while heats up even the air around it. which two laws of thermodynamics could be used to analyze this scenario
Answers: 1
question
Physics, 23.06.2019 09:00
Momentum lab this lab uses a phet simulation. navigate to the phet momentum simulation. if you don’t see the image below when you click on the link, then you need to either enable adobe flash (click on the puzzle piece on your screen) or you need to install adobe flash (this is a free program). change the vectors to be momentum vectors only. they are yellow. make the mass of both balls the same. hit play and notice what happens to the momentum vectors before and after the collision. you might want to play the sim multiple times. click on restart or return balls to start over. to see numbers, check the show values box (inside the green box). red’s momentum vector before the collision is green’s momentum vector after the collision. question 1 options: shorter than longer than equal to question 2 (1 point) saved since green bounces off red, this must be an collision. question 2 options: explosion inelastic elastic question 3 (1 point) red transfers of its momentum to green during the collision. question 3 options: little all most none question 4 (4 points) why does red transfer all its momentum to green? back up your answer with information from the simulation. write at least 2 sentences.
Answers: 1
question
Physics, 23.06.2019 09:30
The text compares alternating current with direct current. how are they different? a alternating current reverses direction in the electrical wiring. direct current flows in one direction only. b direct current reverses direction in the electrical wiring. alternating current flows in one direction only. c direct current is powered by solar energy. alternating current is powered by electrical energy. d alternating current does not move in the electrical wiring. direct current does move in the electrical wiring.
Answers: 2
You know the right answer?
Monochromatic light with wavelength 588 nm is incident on a slit with width 0.0351 mm. The distance...
Questions