Un cañón de electrones dispara electrones (q = -e, me = 9.1 × 10 -31 kg) hacia una placa metálica que está a 4.0 mm de distancia en el vacío. El potencial de la placa es de 5.0 V menor que el del cañón. ¿Cuán rápido se deben mover los electrones al salir del cañón si deben llegar a la placa?

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Determine the maximum r-value of the polar equation r =3+3 cos 0

Engines for propeller-driven aircraft are limited in their maximum rotational speed by the fact that the tip speed of the propeller must not approach the speed of sound in air (mach i). taking 6 ft as a typical diameter for a propeller of a light airplane and 1100 fils as the speed of sound, find the upper limit on the rpm (revolutions per minute) of the propeller shaft.