Physics, 22.05.2020 04:58 msc1595

In Part I, the independent variable, the one that is intentionally manipulated, is
In Part II, the independent variable changes to
The dependent variable, the one you measure the response in, is the same for Parts I and II. For both parts of the
lab, the dependent variable is

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 04:50

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?

Answers: 1

Answer

Physics, 22.06.2019 05:50

High schoolphysics 5+3 pts a neon light consists of a glass tube with metal wires at each end. when connected to a high-voltage source, the gas glows. if a fly lands on the glass tube, what will most likely happen? a) the fly will not feel a shock because the glass conducts any free electrons back into the gas. b) electrons will flow directly from the metal wires along the glass and shock the fly. c) the fly will not feel a shock because the glass insulates it from the electrons in the gas and the metal. d) electrons that are moving through the gas will be conducted through the glass and shock the fly.

Answers: 3

Answer

Physics, 22.06.2019 06:30

What are similarities and differences between refraction, reflection, diffraction and absorption?

Answers: 3

Answer

Physics, 22.06.2019 11:20

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Answers: 3

Answer

You know the right answer?

In Part I, the independent variable, the one that is intentionally manipulated, is
In Part II,...

Questions