subject
Physics, 21.05.2020 19:03 hardwick744

A block is given an initial speed of 3m/s up a 25 incline. coefficient friction =0.12
a. how far up the plane will it go
b. how much time elapses before it returns to it's starting point

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 22:00
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
question
Physics, 22.06.2019 09:30
Astone is dropped from a cliff and falls 9.44 meters. what is the speed of the stone when it reaches the ground? a. 13.6 m/sec b. 1.39 m/sec c. 185 m/sec d. 9.80 m/sec
Answers: 3
question
Physics, 22.06.2019 12:30
Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question
Answers: 1
question
Physics, 22.06.2019 22:00
Aspaceship starting from a resting position accelerates at a constant rate of 9.8 meters per second per second. how far will the spaceship travel if its final speed is 1 percent the speed of light (300,000,000 m/s)? a. 3.1 × 106 m b. 2.94 × 108 m c. 7.8 × 1010 m d. 4.6 × 1013 m
Answers: 1
You know the right answer?
A block is given an initial speed of 3m/s up a 25 incline. coefficient friction =0.12
a. how f...
Questions
question
Mathematics, 17.09.2019 12:10
question
Chemistry, 17.09.2019 12:10
question
Computers and Technology, 17.09.2019 12:10