subject
Physics, 12.05.2020 04:57 jsjsjsskakwkowwj

Gases can be compressed, but liquids cannot. Which statement explains this difference?

A Each molecule in a gas is more compressible than each molecule in a liquid.

B Molecules in a gas are further apart than molecules in a liquid.

C Molecules in a gas attract each other more strongly than molecules in a liquid.

D Molecules in a gas move more slowly than molecules in a liquid.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 22:00
Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)
Answers: 1
question
Physics, 22.06.2019 03:50
Aspecimen of oil having an initial volume of 580cm^3 is subjected to a pressure increase of 4.0 mpa, and the volume is found to decrease by 0.40 cm^3. (a) what is the bulk modulus of the material? (b) what is the compressibility of the material?
Answers: 1
question
Physics, 22.06.2019 18:00
Efficiency is the ratio of to for a system a)power in to power in b)power in to power out c) power out to power out d) power out to power in
Answers: 2
question
Physics, 22.06.2019 19:30
Select light for the type of wave, adjust the wavelength so that the light is red, and increase the amplitude of the light to the max. then, select the start button at the source location to begin producing the waves. light is a form of electromagnetic wave, containing oscillating electric and magnetic fields. the wave amplitude detector mentioned above shows how the electric field oscillates in time at the location of the probe. the amplitude of the wave at the location of the probe is equal to the maximum electric field measured. how does the amplitude of the wave depend on the distance from the source?
Answers: 2
You know the right answer?
Gases can be compressed, but liquids cannot. Which statement explains this difference?

A...
Questions
question
Mathematics, 11.07.2019 04:00