Physics, 26.10.2019 23:43 eheheh80ii

5.85 m/s accelerates at 2.35m/s for 3.25s

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Consider an ordinary, helium-filled party balloon with a volume of 2.2 ft3. the lifting force on the balloon due to the outside air is the net resultant of the pressure distribution exerted on the exterior surface of the balloon. using this fact, we can derive archimedes’ principle, namely that the upward force on the balloon is equal to the weight of the air displaced by the balloon. assuming that the balloon is at sea level, where the air density is 0.002377 slug/ft3, calculate the maximum weight that can be lifted by the balloon. note: the molecular weight of air is 28.8 and that of helium is 4.

Answers: 2

Answer

Physics, 22.06.2019 03:00

Which of the following is an example of units for speed

Answers: 1

Answer

Physics, 23.06.2019 02:30

Intro: a solid ball of radius rb has a uniform charge density ρ. part a: what is the magnitude of the electric field e(r) at a distance r> rb from the center of the ball? express your answer in terms of ρ, rb, r, and ϵ0. part b: what is the magnitude of the electric field e(r) at a distance r express your answer in terms of ρ, rb, r, and ϵ0. part c: let e(r) represent the electric field due to the charged ball throughout all of space. which of the following statements about the electric field are true? check all that apply. e(0) = 0 e(rb)=0 limr→∞e(r)=0 the maximum electric field occurs when r=0 the maximum electric field occurs when r=rb the maximum electric field occurs as r→∞.

Answers: 1

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

5.85 m/s accelerates at 2.35m/s for 3.25s...

Questions