Physics, 16.04.2020 03:00 leelee85503

A series RLC circuit with L = 12 mH, C = 3.5 mu or micro FF, and R = 3.3 ohm is driven by a generator with a maximum emf of 115 V and a variable angular frequency omega. (a) Find the resonant (angular) frequency omega0. rad/s [1.43 points] 0 attempt(s) made (maximum allowed for credit = 10) (b) Find Irms at resonance. A [1.43 points] 0 attempt(s) made (maximum allowed for credit = 10) When the angular frequency omega = 7600 rad/s, (c) Find the capacitive reactance XC in ohms. ohm [1.43 points] 0 attempt(s) made (maximum allowed for credit = 10) Find the inductive reactance XL in ohms. ohm [1.43 points] 0 attempt(s) made (maximum allowed for credit = 10) (d) Find the impedance Z. (Give your answer in ohms.) ohm [1.43 points] 0 attempt(s) made (maximum allowed for credit = 10) Find Irms. A [1.43 points] 0 attempt(s) made (maximum allowed for credit = 10) (e) Find the phase angle (in degrees). degrees

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 15:30

To understand the electric potential and electric field of a point charge in three dimensions consider a positive point charge q, located at the origin of three-dimensional space. throughout this problem, use k in place of 14? ? 0. part adue to symmetry, the electric field of a point charge at the origin must point from the origin.answer in one word.part bfind e(r), the magnitude of the electric field at distance r from the point charge q.express your answer in terms of r, k, and q. part cfind v(r), the electric potential at distance rfrom the point charge q.express your answer in terms of r, k, and q part dwhich of the following is the correct relationship between the magnitude of a radial electric field and its associated electric potential ? more than one answer may be correct for the particular case of a point charge at the origin, but you should choose the correct general relationship. a)e(r)=dv(r)drb)e(r)=v(r)rc)e(r)=? dv(r)drd)e(r)=? v(r)r

Answers: 2

Answer

Physics, 22.06.2019 18:50

Avertical clean glass piezometer tube has an inside diameter of d = 1 mm and is used to measure pressure in a horizontal pipe carrying water as shown. due to pressure in the pipe, the water at 20c rises into the tube to a height h. if the water pressure in the pipe is p = 500 pa gauge, estimate the height h: (a) without considering surface tension (b) with surface tension (capillary) effects. the contact angle  can be assumed at 30 deg

Answers: 2

Answer

Physics, 22.06.2019 19:30

Scientist have use computer models to create a series of maps that show how susceptible coastal cities in island countries are to the sea rising at different levels.the map shows that a 1 meter rise would swap cities all along the us eastern seaboard. a 6-meter sea level rise with sub merge a large part of florida. thermal expansion has already raise the oceans 10 to 20 centimeters the most likely cause,directly and indirectly, for such a rise in sea level is

Answers: 2

Answer

Physics, 22.06.2019 19:30

If the area of a square has increased by a factor of 16, by how much has each side increased?

Answers: 3

Answer

You know the right answer?

A series RLC circuit with L = 12 mH, C = 3.5 mu or micro FF, and R = 3.3 ohm is driven by a generato...

Questions