The range of a projectile fired at an angle with the horizontal and with an initial velocity of feet per second is where r is measured in feet. A golfer strikes a golfball at 115 feet per second. Ignoring the effects of air resistence, at what angle must the golfer hit the ball so that it travels 120 feet? (Round answer to nearest angle.) Question 13 options:

θ = 8.50°

To the nearest angle

θ = 9.0°

the golfer must hit the ball at angle 9° so that it travels 120 feet.

Explanation:

The range of a projectile is the horizontal distance covered by a projectile, which can be written as;

r = (u^2× sin2θ)/g

Where;

r = range

u = initial speed

θ = angle from horizontal

g = acceleration due to gravity

Solving for θ,

sin2θ = rg/u^2

θ = 1/2 × sin⁻¹(rg/u^2) 1

Given;

r = 120 ft

u = 115 ft/s

g = 9.81m/s = 32.2 ft/s

Substituting the values into the equation 1;

θ = 1/2 × sin⁻¹(120×32.2/115^2)

θ = 1/2 × sin⁻¹(0.29217)

θ = 1/2 × 17.00

θ = 8.50°

To the nearest angle

θ = 9.0°

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

multiply 2kg by latent heat of vap