The heat energy associated with a change in temperature that does not involve a change in phase is given by

q=msΔT

where q is heat in joules, m is mass in grams, s is specific heat in joules per gram-degree Celsius, J/(g⋅∘C), and ΔT is the temperature change in degrees Celsius. The heat energy associated with a change in phase at constant temperature is given by

q=mΔH

where q is heat in joules, m is mass in grams, and ΔH is the enthalpy in joules per gram.

Physical constants

The constants for H2O are shown here:
Specific heat of ice: sice=2.09 J/(g⋅∘C)
Specific heat of liquid water: swater=4.18 J/(g⋅∘C)
Enthalpy of fusion (H2O(s)→H2O(l)): ΔHfus=334 J/g
Enthalpy of vaporization (H2O(l)→H2O(g)): ΔHvap=2250 J/g

(a) How much heat must be transferred for this to happen, including the energy needed for phase changes? Your answer should be in terms of the variables in the introduction and the specific heats of ice (ci), water (cw), and steam (cs). The latent heats are Lf = 334 kJ/kg and Lv = 2256 kJ/kg

The cement bag shown in the figure has a mass of 50 kg and the small pulley has a mass of 2 kg. if the cement bag is pulled upwards with an acceleration of 2 m/s^2, find the force f pulling the rope.

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Which car has the most kinetic energy? a. a car of mass 1000 kg with a speed of 3 m/s b. a car of mass 2000 kg with speed 7 m/s c. a car of mass 1000 kg with speed 7 m/s d. a car of mass 2000 kg with speed 3 m/s