subject
Physics, 08.04.2020 01:27 makylahoyle

A cable-operated clutch is being adjusted. Technician A says that free travel is measured at the clutch pedal and should be between 3/4 and 1 inch (19 to 25 mm). Technician B says that the clutch spin-down time should be less than two seconds. Which technician is correct?

A) Technician A only
B) Technician B only
C) Both technicians
D) Neither technician

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 19:00
What term do psychologists use to designate our personal awareness of feelings, sensations, and thoughts?
Answers: 1
question
Physics, 21.06.2019 22:30
25pts the diagram shows the positions of the sun, moon and earth during spring tides, when the high tides are at their highest and low tides at their lowest. what is it about these positions that causes these high and low tides?
Answers: 1
question
Physics, 22.06.2019 00:40
The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.
Answers: 1
question
Physics, 22.06.2019 04:40
Argon is adiabatically compressed from an initial volume of 16 liters to a final volume of 2 liters. by what factor do the following quantities change? do they increase or decrease? (a) the rms speed (b) the thermal energy of the gas (c) the molar specific heat cv (d) the pressure
Answers: 3
You know the right answer?
A cable-operated clutch is being adjusted. Technician A says that free travel is measured at the clu...
Questions
question
Mathematics, 05.11.2020 23:30
question
Mathematics, 05.11.2020 23:30
question
Mathematics, 05.11.2020 23:30