The difference between Lincoln's plan of reconstruction and the Radical Republicans' is that Lincoln wanted to reunite the union as one, while the Radical Republicans thought Lincoln's arrangement was too sympathetic. They felt that the South deserved greater discipline.

The differences between the Lincoln, Johnson, and Congress Reconstruction plans include: Although both the Lincoln and Johnson plan were open to readmission of the southern States, Congress claimed that the two administrations were too lenient and sought stiffer punishment for the States

The aspect of Abraham Lincoln's plan for reconstruction in the South that made it differ from the plan of congressional leaders was that Lincoln's plan was more focused on helping the South rebuild than on punishing it and the Radical Republicans' reconstruction offered all kinds of new opportunities to African Americans, including the vote (for males), property ownership, education, legal rights, and even the possibility of holding political office. By the beginning of 1868, about 700,000 African Americans were registered voters.

Reconstruction encompassed three major initiatives:

1. restoration of the Union

2. transformation of southern society

3.enactment of progressive legislation favoring the rights of freed slaves

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).