subject
Physics, 19.03.2020 04:35 def88

Chemical bond strength greatly influences certain physi- cal properties of a mineral. Rank these properties as to how much (from most to least) they are affected by chemical bonding. (a) color, (b) density, (c) hardness, (d) cleavage.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 17:00
What is the function of the commutator in a dc motor? a. to spin the magnet b. to change direct current into alternating current c. to change alternating current into direct current d. to spin the wire coil
Answers: 1
question
Physics, 22.06.2019 06:00
Suppose water is leaking from a tank through a circular hole of area ah at its bottom. when water leaks through a hole, friction and contraction of the stream near the hole reduce the volume of water leaving the tank per second to cah 2gh , where c (0 < c < 1) is an empirical constant. a tank in the form of a right-circular cone standing on end, vertex down, is leaking water through a circular hole in its bottom. (assume the removed apex of the cone is of negligible height and volume.) (a) suppose the tank is 20 feet high and has radius 8 feet and the circular hole has radius 2 inches. the differential equation governing the height h in feet of water leaking from a tank after t seconds is dh dt = āˆ’ 5 6h3/2 . if the height of the water is initially 8 feet, how long will it take the tank to empty? (round your answer to two decimal places.)
Answers: 2
question
Physics, 22.06.2019 08:00
While studying chemical reactions and conservation of matter, sarah's class conducted a variety of experiments. sarah and her lab partner found the mass of a wax candle and placed the candle in a flask. the students lit the candle and let it burn to completion. all that was left was wax and charred candle wick. per their teacher's instructions, the students found the mass of the products. their data can be seen in the data table. formulate a hypothesis the students could test to explain why the experiment did not support the law of conservation of matter. a) the students could repeat the experiment using different candles; there might have been a flaw in the candle. b) the experiment should be repeatable. the students should run several trials and then take an average of the after mass in each trial. c) the students should have someone in the class check their measurement skills as they repeat the experiment. they may have made an error using the balance. d) the students should burn the candle in a container that has some type of lid so that any gas that is a product of the reaction can be contained and massed. submit
Answers: 2
question
Physics, 22.06.2019 16:50
Acommercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at -35Ā°c by rejecting waste heat to cooling water that enters the condenser at 18Ā°c at a rate of 0.25 kg/s and leaves at 26Ā°c. the refrigerant enters the condenser at 1.2 mpa and 50Ā°c. if the compressor consumes 3.3 kw of power, determine (a) the mass flow rate of the refrigerant, (b) the refrigeration load, (c) the cop, and (d) the minimum power input to the compressor for the same refrigeration load.
Answers: 2
You know the right answer?
Chemical bond strength greatly influences certain physi- cal properties of a mineral. Rank these pro...
Questions