Physics, 16.03.2020 16:48 falgunim4

In order for you to see an object, which of these must happen?

Answers: 3

Show answers

Answers

Answer from: brionna246

A) Light reflected from the object's surface must enter your eyes

Explanation:

To answer the question we need to know the concept tested

The concept is Reflection of light

Reflection refers to the bouncing of light .Reflection is very important in our daily life as it enables us to see various objects and living things around us.For us to see an object, light has to be reflected from the object forming an image at the Retina in our eyes and that way we can see the object.This occurs when signals are sent to the brain to interprate and perceive the details of the object in front of us.

Answer from: Quest

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

Answer from: Quest

answer: the exterior temperature of commercial jet planes as they leave the stratosphere and return to the ground increases steadily.

explanation:

the lower most layer of atmosphere is troposphere which extends from 0 to 12 km above the surface of the earth. the temperature initially decreases as distance is increased from the earth's surface. commercial jets fly in lower part of the stratosphere. the stratosphere extends upto 50 km. the temperature in stratosphere starts rising again due to presence of ozone which traps the uv rays.

thus, when the planes leave the stratosphere and return to the ground, the exterior temperature increases steadily.

Another question on Physics

Physics, 20.06.2019 18:04

Agenerator converts mechanical energy to electrical energy. when a coil placed between two magnets rotates, the magnetic lines of force are disturbed. this induces a current in the coil. the image below shows a generator. what could be done to make the lamp brighter? a. decrease the size of the magnets b. turn the coil slower c. change the polarity of the magnets d. turn the coil faster

Answers: 3

Answer

Physics, 22.06.2019 10:00

Two objects of different mass start from rest, are pulled by the same magnitude net force, and are moved through the same distance. the work done on object 1 is 900 j. after the force has pulled each object, object 1 moves twice as fast as object 2. how much work is done on object 2?

Answers: 1

Answer

Physics, 22.06.2019 12:30

Compare the horizontal displacement of the two balls as they travel to the ground. what do you observe?

Answers: 1

Answer

Physics, 22.06.2019 19:30

Visualize the problem and identify special cases first examine the problem by drawing a picture and visualizing the motion. apply newton's 2nd law, ∑f⃗ =ma⃗ , to each body in your mind. don't worry about which quantities are given. think about the forces on each body: how are these consistent with the direction of the acceleration for that body? can you think of any special cases that you can solve quickly now and use to test your understanding later? one special case in this problem is if m2=0, in which case block 1 would simply fall freely under the acceleration of gravity: a⃗ 1=−gj^.