Physics, 09.03.2020 21:35 Mayrah7486

A block of mass m = 1.5 kg is attached to a spring with spring constant k = 890 N/m.
The spring is attached to a fixed wall.
The block is initially at rest on an inclined plane that is at an angle of θ = 22 degrees with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is μk= 0.15.
In the initial position, where the spring is compressed by a distance of d = 0.15 m, the mass is at its lowest position and the spring is compressed the maximum amount. Assume the initial gravitational energy of the block is zero.
(a) What is the block's initial mechanical energy, E0 in Joules?
(b) If the spring pushes the block up the incline, what distance
L, in meters, will the block travel before coming to rest? The spring remains attached to both the block and the fixed wall throughout its motion.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 03:50

The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error

Answers: 1

Answer

Physics, 22.06.2019 07:30

This is the substance(s) formed in a chemical reaction.

Answers: 1

Answer

Physics, 22.06.2019 17:40

The first-order reaction a→2b+c has rate constant 0.538 s−1. if the initial concentration of a is 0.867 mol l−1, what is the half-life of the reaction in seconds? remember to use correct significant figures in your answer (round your answer to the nearest hundredth). do not include units in your response.

Answers: 3

Answer

Physics, 22.06.2019 21:00

Acentrifuge in a medical laboratory rotates at an angular speed of 3,700 rev/min. when switched off, it rotates through 54.0 revolutions before coming to rest. find the constant angular acceleration (in rad/s2) of the centrifuge. your response is within 10% of the correct value. this may be due to roundoff error, or you could have a mistake in your calculation. carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. rad/s2

Answers: 1

Answer

You know the right answer?

A block of mass m = 1.5 kg is attached to a spring with spring constant k = 890 N/m.
The spri...

Questions