Physics, 22.02.2020 06:06 12375819

Imagine you fill an insulated cup almost full with chopped or crushed ice, and measure the temperature after a minute or two, once it’s all come to thermal equilibrium. Since this ice is frozen water, the temperature should be at 0°C or not more than a couple of degrees below. Then, imagine you add a bunch of salt and stir it around.

What do you think the lowest temperature you can attain will be? Why? What happens to the amount of liquid present if you keep stirring and adding salt? How can we understand this phenomenon in terms of thermal and bond energy systems?

Develop an explanation for the changes you would observe in this physical system (decrease in temperature and change of phase) in terms of the Energy-Interaction Model. Preview the document

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Consider an ordinary, helium-filled party balloon with a volume of 2.2 ft3. the lifting force on the balloon due to the outside air is the net resultant of the pressure distribution exerted on the exterior surface of the balloon. using this fact, we can derive archimedes’ principle, namely that the upward force on the balloon is equal to the weight of the air displaced by the balloon. assuming that the balloon is at sea level, where the air density is 0.002377 slug/ft3, calculate the maximum weight that can be lifted by the balloon. note: the molecular weight of air is 28.8 and that of helium is 4.

Answers: 2

Answer

Physics, 22.06.2019 01:10

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

Answers: 3

Answer

Physics, 22.06.2019 09:30

Need asap ‼️ 20 pts which gravitational force field diagram is drawn correctly? (answers in pictures below)

Answers: 1

Answer

Physics, 22.06.2019 14:30

Lightning is an example of what phenomenon? a release of a large amount of energyan absorption of a large amount of energya natural electric circuita natural electric current

Answers: 1

Answer

You know the right answer?

Imagine you fill an insulated cup almost full with chopped or crushed ice, and measure the temperatu...

Questions